How To Remove Bubbles From The Vinyl Wrap?
While applying vinyl to your car, one of the most frequent problems you might face is the popping up of annoying air bubbles. These are quite frustrating and can ruin your otherwise flawless finish. You can remove bubbles from the vinyl wrap by pushing them out with a squeegee, pricking them with a sharp pin, or using a heat gun over the area. In this blog, we present different effective methods to help you solve this issue easily.
Methods Of Removing Bubbles From Vinyl
If you see bubbles on the surface of your wrap during installation, don’t fret. These can be easily removed using the following ways allowing you to get a professional-grade finish in no time.
1. Squeegee The Bubble Out Of The Vinyl Wrap
A squeegee is a handy tool with a soft felt edge, ideal for getting rid of bubbles on the vinyl without damaging or scratching it. Hold it at an angle then push the bubble down with it and drive the air out from the edge using slight pressure. This technique works best if you are still in the process of installation and haven’t sealed the edges of the wrap yet.
2. Prick The Bubble To Remove It From The Vinyl
If you have finished your wrap job and you see bubbles on the surface, you can use this method to fix them. For pricking the bubble you can use a sharp pin, an air-release pen, or the pointed tip of a precision hobby knife. Here’s what you will do:
- Poke a tiny hole in the center of the bubble. Do not slit it as the cut will show. Just prick it with a pin or with any of the tools mentioned above.
- Use your finger or a squeegee to drive the air out of the hole and press the vinyl down.
- If it is a stubborn bubble, you can use a heat gun to make the vinyl malleable and then press the air out using your fingers or a squeegee.
- Make sure you are wearing gloves. We would not want to leave marks on the vinyl.
3. Get Rid Of Bubbles With A Heat Gun
Another easy way to get rid of bubbles is by applying heat to them with a heat gun. This is great for large-sized bubbles. Here’s what you should do:
How To Prevent Bubbles During Vinyl Installation?
You can prevent bubbles from popping up in the vinyl during installation by taking care of the following points:
- Thoroughly prepare and clean the surface where vinyl will be applied.
- Use premium-quality vinyl with air-release channels and the best vehicle wrap tools.
- When using a squeegee, begin from the center and work outwards. Push the air out from the edges.
- Do not rush the process. Take your time to complete a flawless job.
Frequently Asked Questions
Q. How to get bubbles out of vinyl with a hair dryer?
Ans. A hairdryer will work the same way as a heat gun. Apply heat to the bubble, warming it up, then slowly flatten it with a squeegee.
Q. How To avoid air bubbles in vinyl?
Ans. Yes, DIY car wrapping can be hard, especially for beginners, as it requires expertise, complete knowledge, and the right tools. Proper preparation and practice can improve results.
Q. Can you heat the vinyl to get bubbles out?
Ans. Yes, you can heat the vinyl to remove bubbles using a heat gun or a hair dryer. Be careful not to overheat the film as this will damage it.
Get A Smooth Vinyl Wrap!
With the methods mentioned above, you can get a flawless, bubble-free vinyl wrap with a perfect finish. To get the best tools for this job nearby, visit the Oshark online store. It is a one-stop shop that will help you assemble an ideal toolkit. We deliver internationally, so order now and install vinyl like a pro!